Yamaha blaster tranny oil

Who's good with these things?? I just bought a 98 Yamaha Blaster from a buddy of mine on the cheap who needed some quick cash. He has owned it for several years, and tell me the bottom end has been bored over a bit, the carb has been rejetted, the oil injection removed, different fenders, wider axle in the rear. Needless to say it runs pretty fast except for a little bog down below, but the thing has sat for over a year with only a couple starts here and there with old gas, due to a broken chain.. I'll have the carb cleaned soon.

Yamaha Blaster Leaking Oil From Shifter

blaster gear oil??

Yamaha Blaster Leaking Oil From Shifter This baffle design waterbox is for the stand up and Blaster rider who wants a power increase with a deep throaty sound. A wide variety of classified ads Buy, rent, sell and find anything - yamaha blaster listings. On the gear housing, we can see, from outside to inside : the 4 swing arm mounting bolts, the bearing retainer and its 4 notches, the oil seal really " oily " , the pinion's axle. If it goes out, you will be unable to shift gears properly. Honda R Oil Plug fits both sides. I then changed the coolant but I think the junk I had put in the coolant was what caused the seal to leak.

Why is my fresh tranny fluid milky after < 10 min runtime? (air cooled engine)

When breaking in a new top end you're seating the rings Read this and it explains why you need to run it hard to properly seat the rings. It's also not the best idea to add more oil to the mix as this leans out the fuel air mixture. However small changes won't hurt.

Наливай. По липу Накамуры пробежала быстрая тень, потом он расплылся в широкой - Да, ваше высочество, - склонив голову и кланяясь, он поднес ей напиток. - Что еще угодно вашему высочеству. - проговорил он игриво. - Вот это, - ответила Кэти.

Comments
  • There are no comments yet ...
 
Home Sex Dating